What in the world does this command do?
-q –query bootvmkmod
-d –rootdev UUID=
Queries cannot be combined with each other or other options. Passing -p or -d enables -b even if it is not passed explicitly. -b implies -g plus a new initrd creation. -b and -r are incompatible, but -g and -r can be combined.
Here is some output from my lab:
[[email protected] root]# esxcfg-boot -q boot
272 0:*; UUID=96c048d7-ee1d-4455-b6a5-801bfbaabbdc /vmlinuz-2.4.21-7.ELvmnix /initrd-2.4.21-57.ELvmnix.img
[[email protected] root]# esxcfg-boot -q vmkmod vmklinuxmptscsi_2xx.oe1000.olvmdrivervmfs3etherswitchshapertcpipcosShadow.omigrationnfsclientdeltadiskvmfs2
I am picturing these commands to be much like kernel options, modprobe and bootloader settings you would set up when you compile your kernel in Linux. Most hardcore linux guys would let you know you are a real man when you recompile your own kernel. In VMware, I would be hesitant to mess with any of this unless I broke something. Then again, with all of my VM’s on the SAN, if I bombed out an ESX host this bad, I would take 20 minutes to rebuild it.
What other device driver options beside the hba will you every change?
Here is some things I found:
More HBA problems
And even more queue depth fun
And this list could be longer, just searching VMware Community.
I would guess that the reason we don’t jack with the drivers with ESX and the hardware is becuase of the very good compatibility list. You don’t just run ESX 3.5 on anything (at least not for production).